How To Make A Book Cover From Wrapping Paper

Begin placing the five pieces of binders board onto the cover paper leaving at least 2cm about 1in of cover paper to the left of the first piece. Fold the paper 14 inch above the top and bottom of the book.

Pin On Diy And Freebies

They should be at least 16 in 4 cm in length.

How to make a book cover from wrapping paper. Lay the plastic cover flat on your work surface and lift the book up slightly so the spinal tabs are visible. A book to wrap. Step 6 Poke holes with your scissors.

Then remove the book from the paper. Fold the left edge of the paper in over the cover. Gently wrap the paper around your book ensuring that the book is centered so that there is an even amount of excess paper on each side.

Place your book down on top of the paper and line it up with that folded edge. A pen to mark your creases optional. How to make a book cover using wrapping paper - just in time for back to schoolINSTRUCTIONS.

Faintly mark the edges of the top and bottom of the book then add an extra ¼ inch so that the book will fit inside of the cover. Arrange this edge parallel with the end of the paper. Fold the sides evenly under the books front and back covers to create creases.

Keep the bottom edge of each board butted up against the ruler. Place them with the grain direction moving up and down same as the cover paper. Fold the excess paper around the front and back covers to create gentle creases.

10 Put the cover back on tuck in the remaining flaps and tape them. Close your book and center it on the paper. Place the book on the paper with the text block 1 inch 25 cm from the end.

The jacket should appear complete. Choose the wrapping paper youd like to use and cut it neatly to size. Open your book and mark the top and bottom with a line to show where youll fold your paper.

Step by step guide to covering an exercise book. Use your fingers or a tool a popsicle stick is fabulous for this and press the paper against the books. There should be plenty to spare on both sides to fold over the front and back covers of your book.

Fold the wrapping paper in half so that you can align the spine of the book with the middle. With the front cover open take the left side of your paper and fold it over the cover. Take the book off the paper and fold the paper up to the spot marked and make your fold into a crease.

If you have too much paper and the fold goes too far for your liking cut the excess paper. Make it approximately 25cm larger than the open book all the way round. Wrap the paper up across the top of the book.

HttpbitlyCoverDIY___Find more of Roberts work at httpw. Line-up the cardboard spine and cover. Open the front cover of the book.

Leave a 1 inch 25 cm space between the book and the end of the paper so you have room to wrap the plastic over the inside cover. Unroll and cut enough that will leave about a 2 inch allowance on the top and bottom. Check out the official app httpapp.

Again feel free to use tape to hold the fold in place. A pair of scissors. The tape should not touch the book.

Fold them in and press down firmly on the crease with your fingers. Push the book up approximately a quarter of an inch 025 and fold the top of the paper downward. The text block is the opposite end from the spine.

Lift the front cover of the book and place tape over the seams between the front of the cover and inner flap top and bottom. Duct tape the two together leaving a 116 inch gap between them so the covers open without tension on the spine. Wrapping paper of your choice.

Make a crease along the top cover. You should only tape the wrapping paper together.

Pin On Crafting